Gibson Brands Forums: Relay Mode ? - Gibson Brands Forums

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Relay Mode ? Relay Mode ?

#1 User is offline   scomeau1 

  • Newbie
  • Group: Members
  • Posts: 3
  • Joined: 22-February 13

Posted 15 April 2013 - 06:29 AM

I have two CMP.800 that I have connected by the cable on back but don't know how to get it to run in relay mode.

The manual does not tell you how to do this ?

Thanks for any help you can give me.
0

#2 User is offline   proaudiotech 

  • Advanced Member
  • Group: Gibson Pro Audio
  • Posts: 304
  • Joined: 02-March 12

Posted 22 April 2013 - 07:44 AM

That's strange I found it on page 6 of the manual labeled "Link Up"

http://www.stantondj...ual_English.pdf

Link UP
With this function a USB device can be plugged into a single CMP.800, and a second player can access the data from the drive.
Follow the directions below to setup the link function.
MAIN PLAYER:
a. Press the Menu button to enter the internal menu.
b. Once you are in the internal menu, turn the FOLDER knob until MIDI SETUP is displayed.
c. Press the SHIFT button and turn TRACK knob until the USB = LINK is displayed, and press the Menu button to memorize
the setting and exit.
d. Now load your USB1 device into the MAIN PLAYER.
e. Connect the MAIN PLAYER using the rear USB MIDI port to the second player USB port.
f. You should now be able to access the main player loaded USB1 device using the second player controls.
(The USB1 device must be read first on the main player whenever loaded the device.)
Please note that this is a fan/enthusiast forum - this is not a customer service forum. If you have a customer service issue, please contact the Customer Service dept. Click here for CS contact information..
0

#3 User is offline   Warnerwipsy 

  • Newbie
  • Group: All Access
  • Posts: 9
  • Joined: 27-December 18
  • LocationLa Primavera

Posted 28 December 2018 - 06:04 AM

Thanks for your enquirers.
1, Unfortunately, QK-G021 doesnt support this function now.
2, EXTRT is just to rest the relay to the normal position. It doesnt take any further actions.
Hope above helps.
0

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users