darkside mike Posted December 4, 2014 Share Posted December 4, 2014 Hey guys, I have a 2001 sg standard that i'm sanding down to raw mahogany and I have these two studs coming out of the body but not from a visible insert. How do I remove these? Link to comment Share on other sites More sharing options...
cjsinla Posted December 4, 2014 Share Posted December 4, 2014 They should just unscrew. I would maybe put two small nuts on there and tighten or lock them together. Then use a small wrench to unscrew the post. Either that or pliers and a piece of cloth to protect the threads. Link to comment Share on other sites More sharing options...
darkside mike Posted December 4, 2014 Author Share Posted December 4, 2014 was thinking tape over the threads but was still worried about damaging and didn't think it would work. the two nuts idea is great. thanks a bunch Link to comment Share on other sites More sharing options...
cjsinla Posted December 5, 2014 Share Posted December 5, 2014 was thinking tape over the threads but was still worried about damaging and didn't think it would work. the two nuts idea is great. thanks a bunch Wasn't sure if you would understand that, Tell me how that works. You could also probably use the thumb wheel and a nut screwed downd on top of it. Link to comment Share on other sites More sharing options...
darkside mike Posted December 5, 2014 Author Share Posted December 5, 2014 Wasn't sure if you would understand that, Tell me how that works. You could also probably use the thumb wheel and a nut screwed downd on top of it. Tried the cloth over the posts trick first and it worked perfectly. Thanks Link to comment Share on other sites More sharing options...
cjsinla Posted December 6, 2014 Share Posted December 6, 2014 Tried the cloth over the posts trick first and it worked perfectly. Thanks Great. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.