nmssis Posted April 7, 2016 Share Posted April 7, 2016 Good morning everyone, would anyone know what tool is needed to adjust this type of a trussrod? Thanks! Link to comment Share on other sites More sharing options...
LPS1976 Posted April 7, 2016 Share Posted April 7, 2016 Should be a 4mm hex key Link to comment Share on other sites More sharing options...
nmssis Posted April 7, 2016 Author Share Posted April 7, 2016 Should be a 4mm hex key except there is no hole for the hex key in the head of the protruding rod... Link to comment Share on other sites More sharing options...
Be.eM Posted April 7, 2016 Share Posted April 7, 2016 except there is no hole for the hex key in the head of the protruding rod... Which might be your problem. There should be a nut with the hole for the hex key. Link to comment Share on other sites More sharing options...
nmssis Posted April 7, 2016 Author Share Posted April 7, 2016 Which might be your problem. There should be a nut with the hole for the hex key. man alive, what can be done about this now? the neck has too much of a bow and action is way too high. Link to comment Share on other sites More sharing options...
wrayzor Posted February 28, 2018 Share Posted February 28, 2018 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.