Mickthemiller Posted June 22, 2017 Share Posted June 22, 2017 Here is a tip for anyone who has a scratch plate that is becoming unstuck, particularly the ones with pointy bits like the hummingbird or dove. Lift the scratch plate as far as it will come up. Usually this is less than one inch. Take a piece of double sided tape, about one inch square will do. Press the sticky side to the underside of the scratch plate (do not remove the backing of the tape). Then firmly press the scratchplate, with the tape under it, down onto the guitar top. Hold for a minute or so, then lift up the scratch plate and peel off the whole of the tape - all of it. Then again press the scratch plate firmly to the top. The double sided tape leaves just enough of it of its stickiness to hold the scratch plate down. I know it works cos I've just done it with my hummingbird. Just had another thought. I suppose any adhesive tape would do the trick as it's a matter of getting a bit of the stickiness off the tape on to the underside of the scratchplate Link to comment Share on other sites More sharing options...
AngelDeVille Posted June 22, 2017 Share Posted June 22, 2017 Or heat gently with a hair dryer and use a piece of dental floss to completely remove. Clean, and use 3m doublesided sheets to reattach. WD music sells the sheet for $3 Link to comment Share on other sites More sharing options...
zombywoof Posted June 23, 2017 Share Posted June 23, 2017 I agree with the above that it is a better to remove the pickguard completely, clean, reapply the tape to the back and stick the thing back on. Generally if the scratchplate is lifting one one place it will just find another spot to detach from. Link to comment Share on other sites More sharing options...
GuitarGeordie Posted June 23, 2017 Share Posted June 23, 2017 1498230510[/url]' post='1863846']I agree with the above that it is a better to remove the pickguard completely, clean, reapply the tape to the back and stick the thing back on. Generally if the scratchplate is lifting one one place it will just find another spot to detach from. And if it wasn’t installed “square” at the factory, you can have the satisfaction of knowing you got it right. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.