Jump to content
Gibson Brands Forums

chahua

Members
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral

About chahua

  • Rank
    Newbie
  1. Hi to all, this circuit is my homework maybe, I always short in observe the circuit, but I'm really want to understanding .So please check my understanding of the components http://www.kynix.com/Detail/327276/COMPONENTS.html in the following guitar pedal audio circuit and elaborate/ fill in missing knowledge where necessary. Left of the op-amp inputs R1 & C1 presents an input impedance to the output of the previous circuit C1 sends high frequency in the input signal to ground C2 blocks DC from entering/ leaving via the input R2 loads the C1, C2, R2 filter network to ensure a high impedance - thus the input signal reaches the non-inverting input of the op-amp and doesn't disappear down C2-C1 to ground Above the op-amp R4 and R5 provide a DC-offset for the single supply circuit. C4 filters ripple & noise from the 9V source and works in conjunction with D1 to 'quickly' pass the AC element of back EMF to ground C3 further filters the noise and suppresses ripple, cleaning the bias DC voltage D1 clamps transient current when the DC voltage source is switched on/off (like a flyback diode). The reverse-bias-voltage of the component would have to exceed 9V to prevent the components p-n junction from breaking down (shorting) R3 presents a high impedance at the junction of the non-inverting op-amp input to prevent the audio signal from input source being filtered by C3 Below the op-amp R7 // C6 in conjunction with C5, R6 and the potentiometer set the gain. C6 rolls off 'high' frequencies, reducing their amplification C5 Blocks DC from reaching ground, thus preventing op-amp saturation from amplifying the DC The potentiometer enables variable gain, R6 prevents the gain trying to reach infinity when the potentiometer impedance tends toward zero Shouldn't C5 and R6 be reversed to prevent the DC building up at the inverting terminal of the op-amp? Does this influence build-up of charge & thus saturation? Right of the op-amp output C7 Blocks DC from leaving the circuit via the output R8 presents a higher impedance than C7 and works in conjunction with the potentiometer to provide an output impedance and set the output 'volume' and control the current of the circuit when unloaded? These three components also create a high-pass filter on the output side D2, D3 and D4 asymmetrically 'hard-clip' the signal for a rough distortion sound C8 draws high frequencies to ground to avoid being 'hard-clipped' by the diodes D2, D3 and D4 Thanks in advance Power stabalisation - issues will occur due to C3, C4 and C5 when powering on the circuit. A number of seconds will elapse before the circuit is ready to use at nominal DC bias and gain. Thanks all.
  2. chahua

    hello

    I'm glad to join here, good luck!
×
×
  • Create New...