fevitz GC OZ Posted May 4, 2013 Share Posted May 4, 2013 Hello ! my question is where the tuning knobs tighten at the bridge of a L2 1982 brooklyn bass model . Does anyone know if there should be any washers between the outer bridge and the tuning knob where it turns to tighten the string ? As the jaw is pulled inside the bridge via this knob is seems that it should have a washer . I may be wrong but just asking . thanks for any info . rick Link to comment Share on other sites More sharing options...
Be.eM Posted May 4, 2013 Share Posted May 4, 2013 Hello ! my question is where the tuning knobs tighten at the bridge of a L2 1982 brooklyn bass model . Does anyone know if there should be any washers between the outer bridge and the tuning knob where it turns to tighten the string ? As the jaw is pulled inside the bridge via this knob is seems that it should have a washer . I may be wrong but just asking . thanks for any info . rick Rick, as far as I can see my L2 has two washers on each tuning knob. All other bridges (including guitar bridges) have washers there, too. Bernd Link to comment Share on other sites More sharing options...
fevitz GC OZ Posted May 5, 2013 Author Share Posted May 5, 2013 Rick, as far as I can see my L2 has two washers on each tuning knob. All other bridges (including guitar bridges) have washers there, too. Bernd BERND , THANK YOU ! Im going to have these put in as ive noticed a slight drag when ive had on the rare occasion to check tuning . Id assume they are miniscule in size and probably paper thin . rick Link to comment Share on other sites More sharing options...
Be.eM Posted May 5, 2013 Share Posted May 5, 2013 BERND , THANK YOU ! Im going to have these put in as ive noticed a slight drag when ive had on the rare occasion to check tuning . Id assume they are miniscule in size and probably paper thin . rick Hi Rick, it's a little bit hard to take measurements while they are installed, but I'd say they are about 6.35 mm (1/4") outer diameter and about 0.3 mm thick. Bernd Link to comment Share on other sites More sharing options...
fevitz GC OZ Posted May 6, 2013 Author Share Posted May 6, 2013 Hi Rick, it's a little bit hard to take measurements while they are installed, but I'd say they are about 6.35 mm (1/4") outer diameter and about 0.3 mm thick. Bernd Ill get some of these , we have a nuts and bolts outlet here on the gold coast so ill have no problem getting these , and while im at it i also need an allen key for the the 3 screws on the top of the bridge . They have those as well . thanks again cheers rick Link to comment Share on other sites More sharing options...
fevitz GC OZ Posted May 6, 2013 Author Share Posted May 6, 2013 Hi Rick, it's a little bit hard to take measurements while they are installed, but I'd say they are about 6.35 mm (1/4") outer diameter and about 0.3 mm thick. Bernd Link to comment Share on other sites More sharing options...
fevitz GC OZ Posted May 6, 2013 Author Share Posted May 6, 2013 I would like to add , i played last sat nte . I took my stingray LTD and the steinberger . Ive got the ampeg svt 3 + a pair of 4 x 10 cabs . Both basses absolutely nailed it as i swapped over through the night , but the S B got thumbs up for sustain ,warmth, and fret sound consistency . looking forward to it again . rick Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.