Burstbucker Pro Bridge and Neck output volume

[Lauro Morais 0]

Some years ago I replaced my Epi G400 standard pups for a BB Pro neck and bridge, and since then I've realised that there's a difference in the output volume of these. The neck pup is louder than the bridge one. Is that normal? I've just been wondering why this would happen... Would there be any problem in swapping them in order to have a higher output volume on the bridge?

[Rabs 1,340]

First (if you haven't tried already) try lowering the pickup a bit... It may be set too high...

[Lamaar 0]

They are labeled lead for bridge and rythem for neck, check that.

If that is good than likely the neck pickup is set to high or maybe your bridge pickup is to low.

[Zentar 13]

Adjust the screws to lower the pole pieces or raise the pole pieces on the one that is too quiet. Generally a little bit of pole piece adjustment will accomplish a lot. Also check your side to side humbucker height.

 

Go check youtubes for pole piece adjustment. YouTube is your friend.