Jump to content
Gibson Brands Forums
Sign in to follow this  

Help! Wiring Question for Quick Connect

Recommended Posts

Hey all, I recently got a Les Paul Special Double Cut 2015. Great guitar but the pickups were a bit thin (even for a p90). I decided to replace them with Kent Armstrong Stealth P90s only to realize after opening it up that it was the Quick Connect system.


I decided to cut the Gibson P90s from the clip and remove them and then solder the new pickups into the clip (rather than removing the entire Quick Connect system). KA didn't provide much in the way of color coding so I matched black to black, green to green, ground to ground, red to red, and white to white. I tested them and they worked so I finished up and closed it off.


Once I put strings on I realized that the output was significantly lower than all my other guitars which could mean I have a bad solder job (entirely possible) or the connections aren't quite right. I emailed Kent Armstrong and they said,


"On the pickups you would use red for hot, green and braid for ground and the white and black would either be tied together and soldered or used to wire series and parallel.  We do not advise wiring up to tap a coil (as this is a humbucker two coil design) because the pickup will lose half of the output and not be a noiseless pickup any longer.  Most people solder the black and white together and tape them off.  Hope this helps."


I was able to find a color code for Gibson that I'm hoping someone can verify...


Red = Hot

White = Upper coil finish

Green = lower coil finish

Black = Ground

Shield = Ground


So here is the question. How should I connect them? My guess is


Kent Armstrong ---> Gibson Quick Connect Switch

Red ---> Red

Green ---> Black

Ground ---> Ground


Black and White soldered off and not connected OR

Black ---> Green

White ---> White


Please advise!

Share this post

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

  • Create New...