Jump to content
Gibson Brands Forums
Sign in to follow this  
CurtisB70

Valve Jr. Brown Wire

Recommended Posts

Hello. I have acquired a Valve Jr Head V2 and it has a Hammond OT installed so I opened the amp up to take a look at the inside to see if anything else was changed. There were a few resistors and caps that were replaced but the thing that throws me off is the BROWN wire that runs from the AC in to the power switch. There is a 25 watt 20 Ohm resistor installed in line. Can any one tell me why they would do that? Thank you.

 

New Info: I got to try the amp out today and it was dead quiet till about half way then there was some volume. Cranked all the way up it's clean and not loud at all. So I replaced the (El84) that is labeled 6BQ5 USA GM DELCO with a JJ EL84 and the amp is louder than my other head. I couldn't find much info on the GM tube. Any thoughts? Thanks.

Edited by CurtisB70

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...