kyle Posted March 27, 2009 Share Posted March 27, 2009 Is there any way to map the piezo blend control to a pedal? Link to comment Share on other sites More sharing options...
elantric Posted March 27, 2009 Share Posted March 27, 2009 no It is strictly for adjusting the onboard Piezo Preamp blend / mix with the Mag PUs via a Mono Cable. Link to comment Share on other sites More sharing options...
dirtypurple Posted March 29, 2009 Share Posted March 29, 2009 I thought you were able to split the "acoustic" signal from the pickups via the RIP? that way you could put the piezo signal through one amp/PA and the pickups through another. if you blend in the piezo fully on the guitar, each signal could then have a volume pedal before going into the amp. thats the way i understood it...but of course i dont have the guitar to try it...! Link to comment Share on other sites More sharing options...
elantric Posted March 29, 2009 Share Posted March 29, 2009 The Piezo Blend control only functions when you use a Mono Cable. Use a TRS Cable into the Splitter box - the Acoustic out (TRS RING) is always 100% Use a TRS Cable into the RIP you adjust the mix with the RIP Console App. - the RIP has a flash memory, Set the mix when connected to a PC/ Mac - then disconnect, and the RIP maintains the MIX settings. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.