Jump to content
Gibson Brands Forums

What is the wireing look like on an epi Sherry 2 dot?


LaRouteDu

Recommended Posts

Yes, the import pups only have two wires. Most quality pickups are four wire but on a normal set up would be wired up the same (hot and ground - the shielding goes to ground too). The two remaining wires can be used for coil taping. If you don't care about coil taping you must connect the two wires together and tape them up. On the GFS pups the two coil tap wires are already soldered together, you just need to cover the bare ends of the wires.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...