addison8019 Posted April 17, 2009 Share Posted April 17, 2009 Hi all, I need a schematic for a EPA-FSB to make for my Blues Custom 2x12. They are rare/very expensive here, so I'd rather just make one myself, plus then I can make it tougher/put my own spin on it. I was even thinking of incorporating the switches into a custom pedal board. Anyways any help would be great. Thanks! Link to comment Share on other sites More sharing options...
Eracer_Team Posted April 17, 2009 Share Posted April 17, 2009 http://www.sweetwater.com/store/detail/EPAFSB/ $23.99 Link to comment Share on other sites More sharing options...
addison8019 Posted April 17, 2009 Author Share Posted April 17, 2009 Hi, yeah I realise they sell them, thanks, but having it posted to Australia, and considering the state of the Aussie dollar, I could save heaps by using local parts and making it myself. Plus I could make it 'my way', be a bit of practise too Link to comment Share on other sites More sharing options...
Andyroid Posted April 17, 2009 Share Posted April 17, 2009 Hi, I'm pretty sure they're the same as any two button switch, only the resistance must be less than 1ohm when on, otherwise the amp will be stuck on clean with no reverb. For example the typical marshall two button footswitch would need its LEDs clipping in order to work. Hope this helps. Link to comment Share on other sites More sharing options...
Eracer_Team Posted April 17, 2009 Share Posted April 17, 2009 email or phone these guys http://www.guitar.com.au Link to comment Share on other sites More sharing options...
addison8019 Posted April 18, 2009 Author Share Posted April 18, 2009 Thanks for the replies guys, I'll check it out Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.