Trewblue Posted December 26, 2010 Share Posted December 26, 2010 Thinking of putting GFS pu's in my Dot. Is the switch the only electronics I need to hook up to? seems it would be easier than pulling the pots. also, is there enough wire to pull the switch through the F hole?? Thanks and Happy Holidays Dan Link to comment Share on other sites More sharing options...
brianh Posted December 27, 2010 Share Posted December 27, 2010 Thinking of putting GFS pu's in my Dot. Is the switch the only electronics I need to hook up to? Yes, but if you're going to all that trouble why not replace the electronics too? Some folks here have found that upgrading the electronics made the stock Epi pickups sound so much better that they've left them in. seems it would be easier than pulling the pots. You'll have to pull the pots either way - the pickup (grounds) are soldered to them and to the swtich. also, is there enough wire to pull the switch through the F hole?? Yes. And the switch and output jack should be replaced with Switchcraft while you're at it. Link to comment Share on other sites More sharing options...
bolide Posted January 3, 2011 Share Posted January 3, 2011 Gibson/Epi wiring goes from the Pickups to the pots and then to the switch, this is neccessary for the "Mixing board" control scheme to work. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.