Jump to content
Gibson Brands Forums

Input jack inside semi hollow body!


Freightrain

Recommended Posts

Try to get the jack out of the f-hole, there should be enough wire. Then run some fishing line down through the jack hole and up through the f-hole. Tie it around the jack and pull it back up the hole. When you tighten the nut make sure you use something so the jack doesn't turn when you tighten the nut. Some guys have used a screwdriver and hold the tip of the jack to stop the jack from turning.

 

Good luck. By the way, it's the output jack.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...