Buxom Posted November 25, 2012 Share Posted November 25, 2012 How can I use my Envoy 110 to power a halfstack? I took some photos of all of my hookups. Imgur album here: http://imgur.com/a/VTZAG Link to comment Share on other sites More sharing options...
bonzoboy Posted November 26, 2012 Share Posted November 26, 2012 I have a little 5W Paul amp that was made in Montreal in 1967.the amp sounds incredible and still has the original tubes after thousands of hours of play.Consequently the amp has developed an incredible tone so I wanted to run it through one of my Marshall 4-12 cabinets.I bought an input and installed it in the back of the amp and soldered on the leads from the amp that ran to the amp's own speaker.I then soldered on leads from the speaker to a 1/4" male plug and then just plugged the amp lead into the input.Now if I want to run my amp through my 1960 B cabinet all I have to do is disconnect the speaker lead in the amp and plug a speaker cable into the input of the amp and run it to the cabinet.As long as you have the ohms matched up you shouldn't have any problems. Link to comment Share on other sites More sharing options...
Buxom Posted November 26, 2012 Author Share Posted November 26, 2012 I think they're both 8. Is it just a matter of plugging it in? also, what do I do about the second jack? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.