sledge57 Posted January 10, 2009 Share Posted January 10, 2009 So I've been torturing my dogs ears with my new Sheri and last night I felt something on the neck, a sharp point. Can't hardly see it with out a magnifying glass but you can feel it. Upon further inpection it appears to be a grain of sand in the finish or a bubble. Either way it's no big deal and you hardly ever feel it but knowing it's there bugs me. Anyway to remove something like this with out screwing up the finish? I was wondering about real fine steel wool, 2000 grit paper, polishing compound etc...... I know I could take it back but this was the only one he had and I'm getting attached to it :) Thanks, Link to comment Share on other sites More sharing options...
gilbert_cfc Posted January 10, 2009 Share Posted January 10, 2009 Had the same with My Riviera I got a Stanley Blade and just sliced it off Link to comment Share on other sites More sharing options...
charlie brown Posted January 10, 2009 Share Posted January 10, 2009 Yeah, the fine sandpaper, lightly, a little bit at a time...should do the trick. Then, finish polish it, with MeGuiar's swirl remover, or one of their other fine polishes. CB Link to comment Share on other sites More sharing options...
TWANG Posted January 11, 2009 Share Posted January 11, 2009 +1 on both suggestions. If you get a tiny bit of finish messed up.. min wax wipe on poly can be put over epi finishes with a paper towel.. and just on a spot, too.. but it's good to buff it when you've finished to kep any sort of lines around the area smooth. I doubt you'll have to go that far. TWANG Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.